WIFIHELL - 科技改变生活

 找回密码
 注册WIFIHELL

QQ登录

只需一步,快速开始

开启左侧

[WNDR4500] 网件WNDR4500官方固件下载/DD-WRT下载/刷机指导

  [复制链接]
泛泛之辈 发表于 2014-8-12 09:14:15 | 显示全部楼层
不错正在需要呢
WIFIHELL | 万丰乐活 2020开启新的征程,好货不断!
天翔任心 发表于 2014-8-17 21:54:32 | 显示全部楼层

学教了,谢谢楼主
WIFIHELL | 万丰乐活 2020开启新的征程,好货不断!
autusun 发表于 2014-8-21 23:12:03 | 显示全部楼层
学习啦! 感谢!
WIFIHELL | 万丰乐活 2020开启新的征程,好货不断!
fount007 发表于 2014-9-5 01:13:34 | 显示全部楼层

好东西,必须顶顶
WIFIHELL | 万丰乐活 2020开启新的征程,好货不断!
kelveb 发表于 2014-9-14 17:02:45 | 显示全部楼层
谢谢分享,先学习学习
WIFIHELL | 万丰乐活 2020开启新的征程,好货不断!
wqav 发表于 2014-9-17 15:07:37 | 显示全部楼层
我怎么进不了呢
,能进来学习下吗
WIFIHELL | 万丰乐活 2020开启新的征程,好货不断!
wqav 发表于 2014-9-19 21:12:40 | 显示全部楼层
级别不够 啊,什么时间才能看啊
WIFIHELL | 万丰乐活 2020开启新的征程,好货不断!
pc2002 发表于 2014-9-24 12:00:55 | 显示全部楼层
多谢楼主分享
WIFIHELL | 万丰乐活 2020开启新的征程,好货不断!
Jack 发表于 2014-9-25 10:58:55 | 显示全部楼层
刚好需要,谢谢楼主!!!
WIFIHELL | 万丰乐活 2020开启新的征程,好货不断!
myxieyuyan 发表于 2014-10-3 17:38:30 | 显示全部楼层
谢谢楼主分享!看看怎么救砖
WIFIHELL | 万丰乐活 2020开启新的征程,好货不断!
xlf1234 发表于 2014-10-6 23:57:10 | 显示全部楼层
学习一下 我的变砖了啊
WIFIHELL | 万丰乐活 2020开启新的征程,好货不断!
xishjie 发表于 2014-10-7 00:50:00 | 显示全部楼层
本帖最后由 xishjie 于 2014-10-7 01:35 编辑

http://forum.wifihell.com/home.p ... HybTCgC%2BsRwujSZGd 变砖刷不回去了~郁闷~点了好多次了
WIFIHELL | 万丰乐活 2020开启新的征程,好货不断!
wswih 发表于 2014-10-7 09:33:10 | 显示全部楼层
好文章,就是需要动手做。怕怕啊!
WIFIHELL | 万丰乐活 2020开启新的征程,好货不断!
107166 发表于 2014-10-7 22:51:08 | 显示全部楼层
准备刷原厂,dd不习惯
WIFIHELL | 万丰乐活 2020开启新的征程,好货不断!
xishjie 发表于 2014-10-8 01:53:05 | 显示全部楼层
本帖最后由 xishjie 于 2014-10-8 01:55 编辑



我刷你的DD砖了~怎么办?TTL显示CFE for WNDR4500 version: v1.0.3
Build Date: Thu Jul 21 19:28:03 CST 2011
Init Arena
Init Devs.
Boot partition size = 262144(0x40000)
Found an ST compatible serial flash with 32 64KB blocks; total size 2MB
Found a Samsung NAND flash with 2048B pages or 128KB blocks; total size 128MB
et0: Broadcom BCM47XX 10/100/1000 Mbps Ethernet Controller 5.100.138
CPU type 0x19749: 600MHz
Tot mem: 131072 KBytes

Device eth0:  hwaddr 28-C6-8E-79-DE-60, ipaddr 192.168.1.1, mask 255.255.255.0
        gateway not set, nameserver not set
Checking crc...

CFE for WNDR4500 version: v1.0.3
Build Date: Thu Jul 21 19:28:03 CST 2011
Init Arena
Init Devs.
Boot partition size = 262144(0x40000)
Found an ST compatible serial flash with 32 64KB blocks; total size 2MB
Found a Samsung NAND flash with 2048B pages or 128KB blocks; total size 128MB
et0: Broadcom BCM47XX 10/100/1000 Mbps Ethernet Controller 5.100.138
CPU type 0x19749: 600MHz
Tot mem: 131072 KBytes

Device eth0:  hwaddr 28-C6-8E-79-DE-60, ipaddr 192.168.1.1, mask 255.255.255.0
        gateway not set, nameserver not set
Checking crc...Loader:raw Filesys:raw Dev:nflash0.os File: Optionsnull)
Loading: ....... 3945136 bytes read
Entry at 0x80001000
Closing network.
Starting program at 0x80001000
Linux version 3.10.30 (root@dd-wrt.buildserver) (gcc version 4.7.3 20121106 (prerelease) (Linaro GCC 4.7-2012.11) ) #1233 Wed Feb 19 11:56:43 CET 2014
CPU revision is: 00019749 (MIPS 74Kc)
Found an ST compatible serial flash with 32 64KB blocks; total size 2MB
found nvram at 1F0000
something wrong here. do not remap
Determined physical RAM map:
memory: 07fff000 @ 00000000 (usable)
Zone ranges:
  Normal   [mem 0x00000000-0x07ffefff]
  HighMem  empty
Movable zone start for each node
Early memory node ranges
  node   0: [mem 0x00000000-0x07ffefff]
Primary instruction cache 32kB, 4-way, VIPT, I-cache aliases, linesize 32 bytes.
Primary data cache 32kB, 4-way, VIPT, cache aliases, linesize 32 bytes
Built 1 zonelists in Zone order, mobility grouping on.  Total pages: 32511
Kernel command line: console=ttyS0,115200 root=1f05 rootfstype=squashfs noinitrd init=/bin/sh
PID hash table entries: 512 (order: -1, 2048 bytes)
Dentry cache hash table entries: 16384 (order: 4, 65536 bytes)
Inode-cache hash table entries: 8192 (order: 3, 32768 bytes)
Writing ErrCtl register=80000c00
Readback ErrCtl register=80000c00
Cache parity protection enabled
Memory: 125272k/131068k available (2976k kernel code, 5796k reserved, 606k data, 316k init, 0k highmem)
NR_IRQS:128
CPU: BCM5300 rev 1 at 600 MHz
bcm947xx_clockevent_set_mode: 1
bcm947xx_clockevent_set_mode: 3
console [ttyS0] enabled
Calibrating delay loop... 299.82 BogoMIPS (lpj=1499136)
pid_max: default: 32768 minimum: 301
Mount-cache hash table entries: 512
NET: Registered protocol family 16
bio: create slab <bio-0> at 0
PCI: Initializing host
PCI: Reset RC
PCI: Initializing host
PCI: Reset RC
PCI: scanning bus 0
PCI host bridge to bus 0000:00
pci_bus 0000:00: root bus resource [io  0x0000-0xffff]
pci_bus 0000:00: root bus resource [mem 0x00000000-0xffffffff]
pci_bus 0000:00: root bus resource [bus 00-ff]
PCI: Fixing up bus 0
.....................
found nvram
List of all partitions:
1f00            2048 mtdblock0  (driver?)
1f01              64 mtdblock1  (driver?)
1f02           32768 mtdblock2  (driver?)
1f03           97280 mtdblock3  (driver?)
1f04           32768 mtdblock4  (driver?)
1f05           98304 mtdblock5  (driver?)
1f06              64 mtdblock6  (driver?)
No filesystem could mount root, tried:  squashfs
Kernel panic - not syncing: VFS: Unable to mount root fs on unknown-block(31,5)
Rebooting in 3 seconds..Please stand by while rebooting the system...
Decompressing...done


WIFIHELL | 万丰乐活 2020开启新的征程,好货不断!
aqz121800 发表于 2014-10-16 21:48:05 | 显示全部楼层
正好急需这篇文章
WIFIHELL | 万丰乐活 2020开启新的征程,好货不断!
qaw123 发表于 2014-10-19 20:32:00 | 显示全部楼层
看看怎样修复,刚好有个变砖了
WIFIHELL | 万丰乐活 2020开启新的征程,好货不断!
关闭

站点推荐上一条 /1 下一条

万丰乐活

GMT+8, 2024-12-22 11:18

Powered by Discuz! X3.4

Copyright © 2001-2021, Tencent Cloud.

快速回复 返回顶部 返回列表